Pinion Bearing - Mercury 225 EFI Service Manual

3.0 litre work, electronic fuel injection
Hide thumbs Also See for 225 EFI:
Table of Contents

Advertisement

Pinion Bearing

REMOVAL
NOTE: Inspect the bearing surface on the drive shaft where the needles of the lower pin-
ion bearing roll. The condition of the drive shaft at this location gives an indication of the
condition of the needle bearing. Replace lower pinion bearing (needles and race as a set)
if the drive shaft is pitted, grooved scored, worn unevenly, discolored from overheating,
or has embedded particles.
IMPORTANT: All the needle bearings (18) MUST BE in place inside bearing race
while driving the pinion bearing from the gear housing.
IMPORTANT: Do not reuse the bearing (race or rollers) once it has been removed.
1. Remove and discard the pinion bearing (race and rollers) using tools as shown.
a -
b -
c -
d -
90-884294 OCTOBER 2001
Pinion Bearing
Bearing Driver (91-36569)
Pilot Washer (91-36571)
Driver Rod (91-37323)
d
c
b
a
LEFT HAND NON-RATCHETING
70614
Page 6B-55

Advertisement

Table of Contents
loading

This manual is also suitable for:

250 efi3 liter work 225 efi3 liter work 250 efi

Table of Contents