Flywheel Removal And Installation; Removal - Mercury 225 EFI Service Manual

3.0 litre work, electronic fuel injection

Hide thumbs Also See for 225 EFI:

Table of Contents

Flywheel Removal and Installation

1. Remove flywheel cover from engine.

Engine could possibly start when turning flywheel during removal and installa-

tion; therefore, disconnect (and isolate) spark plug leads from spark plugs to pre-

vent engine from starting.

2. Disconnect spark plug leads from spark plugs.

3. While holding flywheel with flywheel holder (91-52344), remove flywheel nut and

4. Install a crankshaft Protector Cap (91-24161) on end of crankshaft, then install Fly-

wheel Puller (91-849154T1) into flywheel.

5. Hold flywheel tool with wrench while tightening bolt down on protector cap. Tighten

bolt until flywheel comes free.

NOTE: Neither heat or hammer should be used on flywheel to aid in removal as damage

to flywheel or electrical components under flywheel may result.

6. Remove flywheel. Inspect flywheel for cracks or damage.

90-884294 OCTOBER 2001

Flywheel Holder (91-25344)

Flywheel Puller (91-849154T1)

CHARGING & STARTING SYSTEM

Table of Contents

Do you have a question about the 225 EFI and is the answer not in the manual?