Digital Trim Sender - Mercury 225 EFI Service Manual

Trim Indicator Gauge Needle Adjustment
1. Turn ignition key to "RUN" position.
2. Tilt outboard to full "IN" position. Needle of trim indicator gauge should be in full "IN"
position.
3. If not, tilt outboard to full "OUT" position to gain access to trim sender and engage tilt
lock lever.
4. Loosen trim sender screws and reposition trim sender.
5. Tighten trim sender screws.
a -
b -
c -
d -
e -

Digital Trim Sender

Digital trim senders used with Smartcraft gauges are not adjustable.
a -
90-884294 OCTOBER 2001
c
c
a
a
Trim Sender
Screws, Loosen to Rotate Sender
Turn Sender Counterclockwise to raise needle reading
Turn Sender Clockwise to lower needle reading
Tilt lock lever
a
Digital Trim Sender
b
b
d
d
e
POWER TRIM - DESIGN II
22744
58451
Page 5B-63