Connecting Speedometer Pickup - Mercury MerCruiser 3.0 MPI Installation Manual

SECTION - 6
6. Secure the transom assembly with the hardware as shown. Torque the hardware.
Description
Transom assembly hardware
IMPORTANT: Tighten the transom assembly fasteners using an X‑pattern torque sequence,
starting from the middle fasteners. Tighten in small increments and go around the pattern several
times until the proper torque is achieved.
IMPORTANT: Steering lever continuity circuit wire must be positioned as shown to avoid stressing
wire when steering lever moves.
e
a

Connecting Speedometer Pickup

Removing the plug from the speedometer pickup fitting can introduce water into the bilge. Do
not remove the the plug unless you intend to make a connection to a speedometer pickup.
1. Remove the shipping cap from the male quick connect.
90-899883183 DECEMBER 2007
c
b
a - Locknuts and flat washers (8)
b - Hydraulic hoses
c - Drive unit shift cable
d - Trim limit and trim position sender
wires
e - Inner transom plate
DRIVE SYSTEM AND ENGINE INSTALLATION
j
d
3
g
1
8
i
f -
g -
h -
i -
j -
NOTICE
Nm lb. in.
34
h
f
5 7
2
4
6
24401
Transom harness ground wire
Mercathode wires (if equipped)
J‑clip
Torque sequence
Steering lever continuity circuit wire
lb. ft.
25
Page 9 / 54