Mercury 225 EFI Service Manual page 513

RIGHT HAND NON-RATCHETING
IMPORTANT: The bearing MUST BE replaced if removed from gear.
5. Place the universal puller plate between the thrust washer and bearing as shown and
press on the plate until it bottoms.
a -
b -
c -
6. Using a suitable mandrel and the universal puller plate to support the bearing, press
the bearing from the reverse gear as shown.
a -
b -
a. Discard the bearing.
b. Inspect the gear, and thrust washer for excessive wear, cracks, or damage. Re-
Page 6A-22
a
b
c
Universal Puller Plate (91-37241)
Thrust Washer
Bearing
a
b
Universal Puller Plate
(91-37241)
Bearing
place the appropriate components if any of these conditions are found.
d
c
c - Gear
d - Mandrel
23351
23351
90-884294 OCTOBER 2001