Mercury 225 EFI Service Manual page 628

LEFT HAND NON-RATCHETING
9. Install the bearing carrier into the gear housing backwards to hold the propeller shaft
and the pinion nut adaptor in position.
10. Torque the pinion nut to 70 lb. ft. (95 Nm) by turning the drive shaft using the drive shaft
nut wrench and torque wrench.
a -
b -
c -
11. Remove the bearing carrier, pinion nut adapter and drive shaft nut wrench.
12. Torque the retainer to 100 lb. ft. (135 N·m).
a -
13. Remove retainer wrench.
Page 6B-64
c
a
Pinion Nut Adapter (91-61067A2)
Drive Shaft Nut Wrench (91-56775)
Bearing Carrier (installed backwards)
Drive Shaft Bearing Retainer Wrench (91-43506)
b
a
57950
57935
90-884294 OCTOBER 2001