Drive Shaft Housing And Dyna-Float Suspension; Removal And Disassembly - Mercury 225 EFI Service Manual

CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING

Drive Shaft Housing and Dyna-Float Suspension

Refer to "Powerhead Removal" section to remove powerhead. Refer to "Lower Unit
Removal" in this section to remove lower unit.

Removal and Disassembly

1. Remove shift shaft from driveshaft housing by pulling straight up on shaft.
2. Remove power trim wiring harness from exhaust adaptor plate.
3. Remove 3 bolts which secure upper mount cover to adaptor plate. Remove cover.
b
a
a -
b -
c -
d -
e -
Page 5A-8
d
e
Shift Shaft Linkage
Wiring Harness
Adaptor Plate
Bolts
Upper Mount Cover
c
90-884294 OCTOBER 2001
58005