1. If removed, press lower crankshaft ball bearing onto crankshaft as shown. Be sure bear-
ing is pressed firmly against shoulder.
2. Reinstall retaining ring using a suitable pair of Snap Ring Pliers.
a
a
a -
b -
3. If removed, spread new crankshaft sealing rings just enough to slide over crankshaft
journal.
4. Use Piston Ring Expander (91-24697) and install crankshaft sealing rings into groove.
a
5. Lubricate center main crankshaft roller bearings and races with light oil.
14
2 Cycle Outboard Oil
90-884294 OCTOBER 2001
d
d
c
c
b
b
51852
Crankshaft
Crankshaft Ball Bearing
51854
a -
Crankshaft Sealing Rings
b -
Piston Ring Expander (91-24697)
14
a
a -
Install so hole is toward DRIVE SHAFT end of crankshaft
b -
Verify retaining ring bridges the separating lines of the bearing race
e
a
c -
Suitable Mandrel
d -
Press
e -
Retaining Ring
a
a
b
POWERHEAD
55983
b
52320
52318
Page 4A-57