Mercury 225 EFI Service Manual page 689

ATTACHMENTS / CONTROL LINKAGE
STEERING ARM EXTENSION BRACKET INSTALLATION
Secure a steering arm extension bracket to each outboard's steering arm.
a -
b -
c -
d -
Locking retainer corner tabs, MUST BE bent up and against flats on each bolt that
secures extension bracket to outboard steering arm, to prevent bolts from turn-
ing out.
STEERING COUPLER ASSEMBLY AND INSTALLATION
Position outboards so that they are facing straight forward. (Distance between threaded
hole centers of steering arm extensions MUST BE equal to distance between propeller
shaft centerlines.)
Lubricate inside of rubber sleeves with 2-4-C Marine Lubricant with Teflon and slide
sleeves on steering coupler.
Work rubber bushings onto threaded ends of steering eyes.
Thread jam nut on starboard steering eye.
Thread steering eyes equally into coupler, so that distance between hole centers of steer-
ing eye ball joints is equal to distance between threaded hole centers of steering arm ex-
tensions. Exposed threads of steering eyes MUST BE of equal length and threads MUST
NOT extend out from coupler more than 2-3/4 in. (70 mm).
a -
b -
c -
d -
e -
Both steering eyes must be threaded into coupler 3/4 in. (19 mm) minimum.
Thread length of steering eye is 3-1/2 in. (89 mm), so exposed thread must not
extend out of coupler more than 2-3/4 in. (70 mm). Failure to adhere to this re-
quirement could result in steering system failure.
Page 7-22
d
c
Steering Arm (Port Outboard Shown)
Extension Bracket
Locking Retainer (2 Each Bracket)
Bolts (2 Each Bracket) 1-1/4 in. (31.8 mm) Long - Torque to 23 lb. ft. (31 Nm),
Then Bend Corner Tabs of Locking Retainers Up Against Flats on Each Bolt
d e b
c
Coupler
Rubber Sleeve
Steering Eye
Rubber Bushing
Jam Nut
b
d
a
c
51889
WARNING
a b d
c
WARNING
50061
90-884294 OCTOBER 2001