Mercury 225 EFI Service Manual page 455

IMPORTANT: Support outboard as shown above to prevent engine from tipping
when power trim retaining pin is removed.
SUPPORT TOOL
3/8 in. diameter metal rod (a used shift shaft works well)
a -
METRIC CONVERSION
14 in. = 35.56 cm.
3/8 in. = 9.5 mm.
Disconnect battery cables at battery before removing power trim wires from sole-
noids.
4. Disconnect (BLUE and GREEN) bullet connector harness.
5. Open filler cap and release any remaining pressure in the system.
IMPORTANT: Outboards equipped with through-the-tilt-tube steering - remove
steering link arm from end of steering cable and cable retaining nut from tilt tube.
a
a -
b -
90-884294 OCTOBER 2001
a a
2"
Drill holes for retaining clips
2 in. = 50.8 mm
1/4 in. = 6.35 mm.
58444
Filler Cap
Retaining Nut
14"
a
a
1/4"
CAUTION
POWER TRIM - DESIGN II
b
58454
Page 5B-29