Mercury 225 EFI Service Manual page 466

POWER TRIM - DESIGN II
TRIM ROD INSTALLATION
IMPORTANT: Components must be free of dirt and lint. Any debris in the system
can cause system to malfunction.
NOTE: Install trim rod with check valve in the port (left) cylinder.
1. Apply ATF Dexron III or Power Trim and Steering Fluid on all O-rings and seals before
installation.
2. Install trim rods and caps. Use installation tool (91-44487A1) or spanner wrench
(91-74951) to tighten caps securely – 70 lb. ft. (95 N m ).
a
c
a -
b -
c -
Page 5B-40
a
b
Trim Rods
Cylinder End Caps
Rod End Rollers (lubricate with Anti-Corrosion Grease or
Special Lubricant 101)
58450
90-884294 OCTOBER 2001