Mercury 225 EFI Service Manual page 587

3. Pull the bearing carrier from the gear housing by pulling on the outer ring of the bearing
carrier. POSITION PULLER JAWS CLOSE TO BOSSES IN CARRIER.
NOTE: If the bearing carrier is seized in the gear housing, it may be necessary to use heat
to loosen the carrier.
a -
b -
4. Lift the bearing carrier out of the gear housing. Locate and retain the thrust washer
that may be stuck to the inside surface of the bearing carrier.
a
a -
90-884294 OCTOBER 2001
Puller Jaws (91-46086A1)
Puller Bolt (91-85716)
50826
Thrust Washer
LEFT HAND NON-RATCHETING
b
a
50786
a
50779
Page 6B-23