Mercury 225 EFI Service Manual page 533

RIGHT HAND NON-RATCHETING
SHIFT SHAFT ASSEMBLY - Component Disassembly and Inspection
1. Slide the bushing assembly off the shift shaft. Remove the coupler from the shaft.
c
a -
b -
c -
d -
e -
2. Clean all components with a suitable solvent and dry thoroughly with compressed air.
a. Inspect the shift shaft bushing for cracking, damage, or excessive wear.
b. Inspect the oil seal inside the bushing, the sleeve, and the O-rings on the outside
c. Inspect the speedometer connector for damage or blockage.
If any of these conditions exist, replace the appropriate components.
a -
b -
c -
Page 6A-42
b
a
Shift Shaft Bushing Assembly
O-ring
Shift Shaft
Gasket
Rubber Washer
of the bushing for damage or excessive wear.
b
Shift Shaft Bushing
Oil Seal (Oil Seal is Replaceable)
Speedometer Tube Connector
e
d
c
a
90-884294 OCTOBER 2001
57954
57932