Reassembly - Motor And Pump - Mercury 225 EFI Service Manual

POWER TRIM - DESIGN II

Reassembly - Motor and Pump

NOTE: Drive shaft is a loose part and may fall out of position.
1. Install pump into power trim manifold. Insure O-rings are in proper locations. Secure
with 3 screws. Torque screws to 60 lb. in. (7 N·m).
a -
b -
IMPORTANT: Install pump with location flat facing towards starboard transom
bracket.
2. Fill pump with ATF Dexron III or Power Trim and Steering Fluid prior to installing motor.
3. Install motor, secure with 2 screws. Torque screw to 80 lb. in. (9 N m). Route wiring;
refer to Wiring Diagrams in this service manual.
NOTE: Verify motor and drive shaft are aligned.
a -
b -
c -
Page 5B-60
b
a
Oil Pump
Screws (3) Torque to 60 lb. in. (7 N m)]
a
a
b
58610
Motor
O-ring
Screw (2) Torque to 80 lb. in. (9 N m).
58609
c
58611
90-884294 OCTOBER 2001