Decal Application; Decal Removal; Instructions For "Wet" Application - Mercury 225 EFI Service Manual

Decal Application

Decal Removal

1. Mark decal location before removal to assure proper alignment of new decal.
2. Carefully soften decal and decal adhesive with a heat gun or heat blower while remov-
ing old decal.
3. Clean decal contact area with a 1:1 mixture of isopropyl alcohol and water.
4. Thoroughly dry decal contact area and check for a completely cleaned surface.

Instructions for "Wet" Application

NOTE: The following decal installation instructions are provided for a "Wet" installation.
All decals should be applied wet.
TOOLS REQUIRED
1. Plastic Squeegee*
2. Stick Pin
3. Dish Washing Liquid/Detergent without ammonia. DO NOT use a soap that con-
tains petroleum based solvents.
** Automotive Body Filler Squeegee
SERVICE TIP: Placement of decals using the "Wet" application will allow time to
position decal. Read entire installation instructions on this technique before pro-
ceeding.
TEMPERATURE
IMPORTANT: Installation of vinyl decals should not be attempted while in direct
sunlight. Air and surface temperature should be between 60 F (15 C) and 100 F
(38 C) for best application.
SURFACE PREPARATION
IMPORTANT: Do not use a soap or any petroleum based solvents to clean applica-
tion surface.
Clean entire application surface with mild dish washing liquid and water. Rinse surface
thoroughly with clean water.
90-884294 OCTOBER 2001
GENERAL INFORMATION
Page 1C-15