Mercury 225 EFI Service Manual page 128

STARTER SOLENOID TEST
1. Disconnect all wires from solenoid.
2. Use an ohmmeter (R x1 scale) and connect meter leads between solenoid terminals
1 and 2.
3. Connect a 12-volt power supply between solenoid terminals 3 and 4. Solenoid should
click and meter should read 0 ohms (full continuity).
4. If meter does not read 0 ohms (full continuity), replace solenoid.
a -
b -
90-884294 OCTOBER 2001
b
1
4
a
12 Volt Supply
VOA Leads
a
3
b
2
CHARGING & STARTING SYSTEM
51809
Page 2B-37