LEFT HAND NON-RATCHETING
Drive Shaft - Bearing Preload Tool
REMOVAL
Before loosening the top nut allen screws of the bearing preload tool, screw the
bottom nut up as close as possible to the top nut.
1. Remove the dial indicator and its supporting tooling.
2. Screw the bottom nut of the bearing preload tool until it is as close as possible to top
nut.
3. Loosen the allen screws in the top nut.
4. Remove all components.
a -
b -
c -
Page 6B-68
c
Top Nut (with allen screws)
Bottom Nut
Plate
CAUTION
a
b
57936
90-884294 OCTOBER 2001