Separating Engine; Separating Front Axle Support As A Unit - Kubota M108S Workshop Manual

M108S, WSM

[2] SEPARATING ENGINE

(1) Separating Front Axle Support as a Unit

Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug (1).
3. Remove the radiator cap to completely drain the coolant.
4. After all coolant is drained, reinstall the radiator drain plug.
Coolant Capacity
(1) Drain Plug
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plugs (1) to drain oil.
4. After draining, screw in the drain plugs (1).
(When reassembling)
• Fill the engine oil up to the upper line on the dipstick (2).
Engine Oil Capacity
IMPORTANT
• Never mix two different type of oil.
• Use the proper SAE Engine Oil according to ambient
temperature.
Refer to "7. CHECK
LUBRICANTS, FUEL AND COOLANT" at "G. GENERAL"
section
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet Plug
1-S18
9.6 L
10.0 U.S.qts
8.4 Imp.qts
10.7 L
11.3 U.S.qts
9.41 Imp.qts
AND MAINTENANCE" and "4.
(A) Oil level is acceptable within this
range.
ENGINE
W1030568
W1030778
KiSC issued 06, 2007 A