Disassembling And Assembling; Separating Engine From Clutch Housing - Kubota MX5100 Workshop Manual

MX5100, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Separating Engine from Clutch Housing

Draining Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from oil inlet port after removing the oil inlet (2) up to the
line of the level gauge (3).
• After running the engine for few minutes, stop it and check the oil
level again, add the transmission fluid to prescribed level if its
level is not correct level.
Transmission fluid capacity
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Gauge
(3) Oil Inlet
2-S7
CLUTCH
44.0 L
11.6 U.S.gals
9.7 lmp.gals
(A) Oil level is acceptable within this
range.
W1092616