Kubota M108S Workshop Manual page 171

Hide thumbs Also See for M108S:

Table of Contents

Crankcase 1 and Crankcase 2

(When reassembling)

• Match the crankcase 1 and 2, referring to the flywheel housing's

contoured face.

• Tighten the crankcase 2 mounting screws loosely.

• Tighten up the flywheel housing to the specified torque. This

helps to minimize the level difference between the crankcase 1

and the crankcase 2 (at the flywheel side). Possible gap must be

0.05 mm (0.002 in.) or smaller.

Crankcase 2 mounting

Tightening torque

Flywheel housing

mounting screw

(1) Crankcase 1

(2) Gap to be smaller than 0.05 mm

49 to 55 N·m

5.0 to 5.7 kgf·m

37 to 41 lbf·ft

78 to 90 N·m

7.9 to 9.2 kgf·m

58 to 66 lbf·ft

(3) Flywheel Housing

(4) Crankcase 2

KiSC issued 06, 2007 A

Chapters

Table of Contents