Swing Shift - Kubota M108S Workshop Manual

M108S, WSM

[3] SWING SHIFT

Operation Method
1. The swing shift is a method which the HI and LO
speed range is changing by using the electric and
hydraulic device combination.
2. The main gear shift lever is in Neutral position during
the engine is running.
Move the lever against the left side face, and the
speed changes each time between the rabbit lamp-HI
(2) and turtle lamp-LO (3).
Be sure to use the clutch while shifting.
3. The lamp (2), (3) indicate that the shift is change
between HI speed range (2) and LO speed range (3).
4. The buzzer sounds when the shifting has occurred
with both the lamps (2), (3) off.
5. When moving the main gear shift lever (4) against the
left side at "Neutral", the swing shift switch (6) is
turned each time between rabbit (HI) and turtle (LO).
Battery current flows from swing shift switch (4) to
solenoid valve (7) or (8), then solenoid valve is
actuated.
6. As for buzzer, the HI or LO monitor switch is turned
ON according to the movement of the HI-LO shift rod,
battery current flows from swing shift switch to buzzer
relay through the monitor switch.
Buzzer relay is actuated, battery current flows to
buzzer.
(1) Main Gear Shift Lever
(2) Rabbit Lamp-HI
(3) Turtle Lamp-LO
(4) Main Shift Lever
(5) Buzzer
(6) Swing Shift Switch
(7) LO Solenoid Valve
3-M18
TRANSMISSION
(8) HI Solenoid Valve
N : Neutral Position
A : Direction for Swing Shift
Operation
W1013666
KiSC issued 06, 2007 A