Checking, Disassembling And Servicing; Checking And Adjusting - Kubota M108S Workshop Manual

M108S, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

Adjusting Brake Pedal
1) Brake Pedal Free Travel
CAUTION
• When checking, parking the tractor on flat ground, and stop
the engine.
1. Measure the free travel by depressing the brake pedals.
2. Slightly depress the brake pedals and measure free travel at the
top of pedal stroke.
3. If the measurement is not within the factory specifications, adjust
the free travel by the push rod (2).
4. After adjustment, tighten the lock nut firmly.
IMPORTANT
• Keep the free travel in the right and left brake pedals equal.
Brake pedal free travel Factory spec.
(1) Brake Pedal
(2) Push Rod
2) Brake Pedal Stroke and Difference between Right and Left
Pedal Strokes
CAUTION
• When checking, park the tractor on flat ground, and stop the
engine.
1. Disengage the brake pedal lock.
2. Step on either side brake pedal and measure the level difference
(pedal stroke) between right and left pedals.
3. Do the same for the other side.
4. If the pedal stroke exceeds the factory specification, check the air
bleeding, master cylinder, equalizer or brake case.
Brake pedal stroke Factory spec.
Difference between left
and right brake pedal Factory spec.
stroke
(1) Brake Pedal LH
(2) Brake Pedal RH
(3) Brake Pedal Lock
5-S4
BRAKES
7.0 to 14 mm
0.28 to 0.55 in.
A : Free Travel
W1012803
Less than 100 mm
3.94 in.
0 to 5.0 mm
0 to 0.19 in.
A : Pedal Stroke
W1012972
KiSC issued 06, 2007 A