Removing Pto Clutch Valve - Kubota M108S Workshop Manual

M108S, WSM

(3) Removing PTO Clutch Valve

Gear Pump and Pump Base Assembly
1. Remove the seat (1) and floor cover (2).
2. Remove the floor mat (3) and inspection plate under the floor
mat.
3. Remove the delivery pipe 1 (4) and delivery pipe 2 (5).
4. Remove the lowering speed adjustment rod (6).
5. Disconnect the parking brake cable (7).
6. Disconnect the PTO clutch cable (8).
7. Disconnect the suction pipes (11).
8. Remove the pump base (9) with gear pump.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of transmission case and valve assembly.
• Replace the oil pipes (10) with new ones.
• Be sure to check the PTO clutch lever movement. (Refer to "[1]
CHECKING AND ADJUSTING" in this section.)
Delivery pipe 1 and 2
retaining nut
Tightening torque PTO pipe retaining nut
Pump base mounting nut
(1) Seat
(2) Floor Cover
(3) Floor Mat
(4) Delivery Pipe 1
(5) Delivery Pipe 2
(6) Lowering Speed Adjusting Rod
2-S15
CLUTCH
108 to 117 N·m
11.0 to 12.0 kgf·m
79.6 to 86.7 lbf·ft
30 to 39 N·m
3.0 to 4.0 kgf·m
22 to 28 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(7) Parking Brake Cable
(8) PTO Clutch Cable
(9) Pump Base
(10) Oil Pipe
(11) Suction Pipe
(12) PTO Pipe
W1017134
KiSC issued 06, 2007 A