Kubota M108S Workshop Manual page 170

M108S, WSM
Flywheel Housing
1. Remove the flywheel housing.
(When reassembling)
• Apply liquid gasket (Three Bond 1217D or equipment) to flywheel
housing.
• Confirm that the liquid gasket coating surface is free of water,
dust and oil in order to maintain sealing effect.
• Be careful not to damage the oil seal when installing the flywheel
housing to the crankshaft.
• Be careful not to place the oil seal tilted.
• Tighten the flywheel housing mounting screws with even force on
the diagonal line.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
Flywheel housing
Tightening torque
mounting screw
(1) Flywheel Housing
Crankcase 2
1. Remove the crankcase 2 (1).
(When reassembling)
IMPORTANT
• Make sure the crankcase 1 and 2 are clean.
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2
as shown in the figure.
• Tighten the crankcase 2 mounting screws with even force on
the diagonal line.
• Confirm that the liquid gasket coating surface is free of
water, dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
Crankcase 2 mounting
Tightening torque
screw
(1) Crankcase 2
1-S47
ENGINE
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(2) Oil Seal
W1056964
49 to 55 N·m
5.0 to 5.7 kgf·m
37 to 41 lbf·ft
(2) Liquid Gasket
W1060825
KiSC issued 06, 2007 A