Kubota M108S Workshop Manual page 77

M108S, WSM
NOTE
• The following special tools are not provided, so make them referring to the figure.
Draft Control Test Bar
Application: Use for checking the lift range and floating range of
hydraulic draft control.
A 1045 mm (41.14 in.)
B 1000 mm (29.37 in.)
C 20.0 mm dia. (0.787 in. dia.)
D 30.0 mm dia. (1.18 in. dia.)
E 90.0 mm (3.54 in.)
F 36.5 mm (1.44 in.) (Top link mounting hole)
G 30.0 mm (1.18 in.)
H 15.0 mm (0.591 in.)
I 26.0 mm dia. (1.02 in. dia.)
J Weld all around
K Weld all around
L 20.0 mm (0.787 in.)
Hydraulic Arm Shaft Bushing Press-Fitting Tool
Application : Use for replacing the hydraulic arm shaft bushings in
the hydraulic cylinder body.
Right
64.75 to 64.95 mm
A
(2.550 to 2.557 in.)
17.5 to 18.5 mm
B
(0.689 to 0.728 in.)
C 60.0 mm (2.36 in.)
D 32.0 mm (1.26 in.)
59.970 to 59.999 mm
E
(2.3611 to 2.3621 in.)
F 70.0 mm dia. (2.76 in. dia.)
G 40.0 mm dia. (1.57 in. dia.)
H 50.0 mm (1.97 in.)
I 10.0 mm (0.397 in.)
6.3 μm (250 μin.)
a
6.3 μm (250 μin.)
b
6.3 μm (250 μin.)
c
6.3 μm (250 μin.)
d
G-60
G GENERAL
W10625190
Left
69.75 to 69.95 mm
(2.746 to 2.753 in.)
13.5 to 14.5 mm
(0.532 to 0.570 in.)
40.0 mm (1.57 in.)
64.970 to 64.990 mm
(2.5579 to 2.5586 in.)
W10316550
KiSC issued 06, 2007 A