Removing Shuttle Clutch Valve - Kubota M108S Workshop Manual

M108S, WSM

(2) Removing Shuttle Clutch Valve

Damper Disc
1. Remove the damper disc (1).
(When reassembling)
• Confirm that the bearing (2) is surely assembled to the flywheel.
• Direct the shorter end of the damper disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the shaft A.
IMPORTANT
• Align the center of damper disc and flywheel by inserting the
clutch center tool (3) (Code No. 07916-53041).
Damper disc mounting
Tightening torque
screw
(1) Damper Disc
(2) Bearing
Shuttle Clutch Valve
1. Remove the floor mat (1) and inspection plate (2).
2. Remove the shuttle valve (3).
(When reassembling)
HI-LO pipe retaining nut
Tightening torque Delivery pipe retaining nut
Shuttle valve mounting
screw
(1) Floor Mat
(2) Inspection Plate
(3) Shuttle Valve
2-S14
CLUTCH
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(3) Clutch Center Tool
W1016312
30 to 39 N·m
3.0 to 4.0 kgf·m
22 to 28 lbf·ft
49 to 68 N·m
5.0 to 7.0 kgf·m
37 to 50 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(4) Delivery Pipe
(5) HI-LO Pipe
W1016768
KiSC issued 06, 2007 A