Kubota M108S Workshop Manual page 349

Hide thumbs Also See for M108S:

Table of Contents

Planetary Gear

1. Remove the external snap ring (1).

2. Remove the planetary gear support assembly.

3. Tap the spring pin (6) into the planetary gear shaft (5).

4. Draw out the planetary gear shaft (5), and remove the planetary

5. Tap out the spring pin (6) from the planetary gear shaft (5).

(When reassembling)

• Apply gear oil to the needle bearing (4).

• Tap in the spring pin (6) as shown in the figure left.

(1) External Snap Ring

(2) Thrust Collar

(3) Planetary Gear

1. Tap out the front axle from front wheel case cover.

(When reassembling)

• Apply grease to the front axle oil seal (1).

• Install the oil seal to the front wheel case cover so that its lip faces

(1) Oil Seal

(4) Needle Bearing

(5) Planetary Gear Shaft

(6) Spring Pin

KiSC issued 06, 2007 A

Chapters

Table of Contents