Kubota M108S Workshop Manual page 263

M108S, WSM
Gear Pump and Pump Base
1. Remove the suction pipes (1).
2. Remove the delivery pipes (2).
3. Remove the PTO pipe (3).
4. Remove the pump base with gear pumps.
(When reassembling)
• Replace the oil pipes with new ones and apply oil to them.
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of pump base and transmission case.
Delivery pipe 1 and 2
retaining nut
Tightening torque PTO pipe retaining nut
Pump base mounting nut
(1) Suction Pipe
(2) Delivery Pipe
(3) PTO Pipe
Separating Transmission Case
1. Remove the dual speed HI clutch pipe (5) and LO clutch pipe (1).
2. Remove the resonator pipe (3).
3. Remove the parking brake cable stay (6).
4. Remove the delivery pipe (2).
5. Remove the lubrication pipe (4).
6. Remove the transmission case mounting screws and nuts.
7. Separate the transmission case from the mid case (8).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of transmission case and mid case.
Transmission case and
Tightening torque mid case mounting screw
and nut
(1) LO Clutch Pipe
(2) Delivery Pipe
(3) Resonator Pipe
(4) Lubrication Pipe
(5) HI Clutch Pipe
3-S17
TRANSMISSION
108 to 117 N·m
11.0 to 12.0 kgf·m
79.6 to 86.7 lbf·ft
30 to 39 N·m
3.0 to 4.0 kgf·m
22 to 28 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(4) Pump Base
(5) Oil Pipe
W1032659
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(6) Parking Brake Cable Stay
(7) Mid Case
(8) Transmission Case
(9) Nut
W1037357
KiSC issued 06, 2007 A