Kubota M108S Workshop Manual page 268

M108S, WSM
Hi-Lo Shift Fork
1. Remove the Hi and Lo monitor switch (9).
2. Remove the internal snap ring (1) and seal cap (2).
3. Remove the spring pin (4).
4. Remove the fork rod (3) by using M6 x Pitch 1 screw into the
thread (10).
NOTE
• Pay attention so as not to lose the detent ball (7) and spring
(8).
(When reassembling)
• Apply grease to the detent ball (7).
• Apply transmission fluid to the seal cap (2) and fork rod (3).
(1) Internal Snap Ring
(2) Seal Cap
(3) Fork Rod
(4) Spring Pin
(5) Hi-Lo Shift Fork
3-S22
TRANSMISSION
(6) Guide Chip
(7) Detent Ball
(8) Spring
(9) Monitor Switch
(10) Thread
W1025356
KiSC issued 06, 2007 A