Disassembling Shuttle Case - Kubota M108S Workshop Manual

M108S, WSM

[2] DISASSEMBLING SHUTTLE CASE

Shuttle Case Assembly
CAUTION
• The shuttle case assembly is heavy, so that take care it when
handling.
1. Remove the screws and nut.
2. Remove the shuttle case assembly (1) by using M8 x Pitch 1.25
screws into holes A and B.
(When reassembling)
• The passage hole of oil is not closed with liquid gaskets.
• Apply liquid gaskets (Three Bond 1206C or equivalent) to joint
face of the shuttle case and clutch housing case.
Shuttle case mounting
Tightening torque
screw and nut
(1) Shuttle Case Assembly
Disassembling Shuttle Case Assembly
1. Remove the external snap ring (8).
2. Top out the input shaft (2) with shuttle clutch and 26T gear shaft
(3) together.
(When reassembling)
• Replace the seal rings (5), oil seal (6), sleeve (7) external snap
rings (8) with new ones.
• Be sure to install sleeve (7) as shown figure.
• Apply transmission fluid to seal rings (5) and bearings.
• Apply grease to oil seal and sleeve.
NOTE
• Do not get in the seal rings (5) between input shaft (2) and
shuttle case.
(1) Shuttle Case Assembly
(2) Input Shaft
(3) 26T Gear Shaft
(4) Shuttle Clutch Assembly
(5) Seal Ring
(6) Oil Seal
3-S19
TRANSMISSION
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
A : Threaded Hole
B : Threaded Hole
W1021922
(7) Sleeve
(8) External Snap Ring
a : Front Side
b : Rounded Edge
W1022188
KiSC issued 06, 2007 A