Kubota M108S Workshop Manual page 214

M108S, WSM
Separating Transmission Case
1. Remove the dual speed HI clutch pipe (4) and LO clutch pipe (5).
(DS model only.)
2. Remove the resonator pipe (9).
3. Remove the parking brake cable stay (6).
4. Remove the delivery pipe (8).
5. Remove the lubrication pipe (7).
6. Remove the transmission case mounting screws and nuts.
7. Separate the transmission case from the mid case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of transmission case and mid case.
Transmission case and
Tightening torque mid case mounting screw
and nut
(1) Mid Case
(2) Transmission Case
(3) Nut
(4) HI Clutch Pipe
(5) LO Clutch Pipe
Dismounting Hydraulic Cylinder Assembly
1. Remove the hydraulic cylinder assembly mounting screws and
nut.
Support the hydraulic cylinder assembly (1) with nylon lift strap
and hoist, and then remove it.
2. Dismounting the hydraulic cylinder assembly from transmission.
(When reassembling)
• Change the hydraulic cylinder gasket to new one.
Hydraulic cylinder
Tightening torque assembly mounting screw
and nut
(1) Hydraulic Cylinder Assembly
Rear Axle Case and Parking Brake Case
1. Remove the rear axle case mounting screws and nuts.
2. Support the rear axle case with nylon lift strap and hoist.
3. Separate the rear axle case from transmission case.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the rear axle case and transmission case, after eliminate
the water, oil and stuck liquid gasket.
Rear axle case mounting
Tightening torque
screw
2-S19
CLUTCH
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(6) Parking Brake Cable Stay
(7) Lubrication Pipe
(8) Delivery Pipe
(9) Resonator Pipe
W1022354
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
W1022741
118 to 147 N·m
12.0 to 15.0 kgf·m
86.8 to 108 lbf·ft
W1023029
KiSC issued 06, 2007 A