Disassembling And Assembling; Separating Each Block; Transmission Case) - Kubota M108S Workshop Manual

M108S, WSM

5. DISASSEMBLING AND ASSEMBLING

[1] SEPARATING

TRANSMISSION CASE)

EACH BLOCK
Draining Transmission Fluid
1. Place oil pan underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When reassembling)
• Fill up from filling port (2) after removing the filling plug up to the
upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not correct
level.
Capacity
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oil may
damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT" at "G.
GENERAL" section.
• Do not mixed different brands fluid together.
(1) Drain Plug
(2) Dipstick
(3) Filling Port
Draining Fuel
1. Place oil pans under the right side fuel tank.
2. Remove the drain cover (2) at the bottom of side fuel tank (1).
3. Drain the fuel.
4. Reinstall the drain cover (2) on the fuel tank (1).
(When reassembling)
• Be sure to fix the O-ring (3) is in position on the drain cover (2).
Fuel Tank
(1) Fuel Tank
(2) Drain Cover
Separating Cabin from Tractor Body
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "10.
CABIN" section.
2. Check the clutch housing case and transmission case are
securely mounted on the disassembling stands.
3. Remove the rear wheels.
(When reassembling)
Tightening torque
3-S14
(CLUTCH HOUSING
Transmission fluid
A : Oil level is acceptable with this
Capacity
(3) O-ring
(4) Screw
Rear wheel mounting nut
TRANSMISSION
CASE AND
60.0 L
63.4 U.S.qts.
52.7 Imp.qts.
range.
W1011383
175 L
46.2 U.S.gals
38.4 Imp.gals
W1028925
344 to 402 N·m
35 to 41 kgf·m
254 to 296 lbf·ft
W1029089
KiSC issued 06, 2007 A