Disassembling And Assembling; Separating Engine From Clutch Housing - Kubota B1830 Workshop Manual

B1830,B2230,B2530,B3030, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Separating Engine From Clutch housing

Draining Transmission Fluid
1. Place oil pan underneath the transmission case, and remove
the drain plugs (3).
2. Drain the transmission fluid.
3. Reinstall the drain plug (3).
(When refilling)
• Fill new oil from port after remaining the filling plug (2) up to the
upper notch on the dipstick (1).
• After running the engine for new minutes, stop it and check the
oil level again, it low, add oil prescribed level.
IMPORTANT
• Use only KUBOTA SUPER UDT fluid-Use of the other oils
may damage the transmission or hydraulic system.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for
a few minutes to prevents damage to the transmission.
• Do not mix different brands oil together.
B1830, B2230, B2530
Manual transmission
(without Bi-Speed Turn)
Transmission fluid
capacity
B1830, B2230, B2530
Manual transmission
(with Bi-Speed Turn)
(1) Dipstick
(2) Filling Plug
(3) Drain Plug
(4) Drain Plug (Rear Axle Case)
(A) Oil level is acceptable within this
range.
2-S5
CLUTCH
15 L
4.0 U.S.gals
3.3 Imp.gals
16.5 L
4.4 U.S.gals
3.6 Imp.gals
a: B3030HD (Serial No. 90000 and
below), B2530HD (Serial No.
90000 and below), B2530D (Serial
No. 50000 and below), B2230HD
(Serial No. 90000 and below),
B2230D (Serial No. 50000 and
below), B1830D (Serial No. 50000
and below)
b: B3030HD (Serial No. 90001 and
above), B2530HD (Serial No.
90001 and above), B2530D (Serial
No. 50001 and above), B2230HD
(Serial No. 90001 and above),
B2230D (Serial No. 50001 and
above), B1830D (Serial No. 50001
and above)
9Y1210003CLS0005US0
KiSC issued 05, 2012 A