Kubota M108S Workshop Manual page 343

M108S, WSM
Draining Front Axle Gear Case Oil
1. To drain the used oil, remove the right and left drain plugs (2) and
filling plugs (1) at the front axle gear case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the filling plug port.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" at "G.
GENERAL" section.
4. After filling, reinstall the filling plugs (1).
Front Axle Gear Case
Capacity
Oil
(1) Filling Plug
Propeller Shaft
1. Slide the propeller shaft cover (3) after removing the screw (5).
2. Tap out the spring pins (2) and then slide the coupling (1) to the
rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (6) and pinion
shaft.
• Tap in the spring pins (2) as shown in figure.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
6-S7
FRONT AXLE
3.5 L
3.7 U.S.qts.
3.1 Imp.qts.
for each side
(2) Drain Plug
W1013799
(5) Screw
(6) Propeller Shaft
(7) Coupling
W1019695
KiSC issued 06, 2007 A