Preparation; Separating Clutch Housing And Engine - Kubota WSM L3540-II Workshop Manual

L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM

5. PREPARATION

[1] SEPARATING CLUTCH HOUSING AND ENGINE

Draining the Transmission Fluid
WARNING
• Be sure to stop the engine before draining the transmission
fluid.
• Allow the engine to cool down sufficiently, oil can be hot
and burn.
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid completely.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, add the fluid to prescribed level if it is not correct
level.
Transmission fluid Capacity
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-10.)
• Do not mix different brands of fluid together.
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
2-S6
40 L
L3540-II 10.6 U.S.gals
8.8 Imp.gals
L4240-II
43 L
Manual
11.4 U.S.gals
Transmission
9.5 Imp.gals
Model
39 L
L4240-II
10.3 U.S.gals
HST Model
8.6 Imp.gals
46 L
L5040-II 12.2 U.S.gals
10.1 Imp.gals
41 L
L5240-II,
10.8 U.S.gals
L5740-II
9.0 Imp.gals
A: Oil level is acceptable within this
range.
[a] HST Model
[b] GST/Manual Transmission Model
9Y1211167CLS0028US0
CLUTCH
KiSC issued 02, 2015 A