Disassembling Mid Case - Kubota M108S Workshop Manual

M108S, WSM

[5] DISASSEMBLING MID CASE

Bearing Support and Dual Speed Clutch
1. Tap out the 27T gear shaft (2) and 25T gear (4) with bearing (3)
together.
2. Remove the bearing (6) and external snap ring (5).
3. Remove the bearing support mounting screws.
4. Tap out the 20T gear shaft (7) with bearing support.
(When reassembling)
• Check the 20T gear shaft rotation smoothly after assembling the
bearing support to mid case.
• Apply transmission fluid to the bearings.
• Confirm the moving of the piston smoothly when pressure air at
0.49 to 0.98 MPa (5.0 to 10 kgf/cm
clutch pack from oil supply port on mid case side.
Bearing support mounting
Tightening torque
screw
(1) Bearing Support
(2) 27T Gear Shaft
(3) Bearing
(4) 25T Gear Shaft
Bearing Support
1. Remove the external snap ring (1).
2. Remove the feather key (2) and tap out the 20T gear shaft (3).
(When reassembling)
• Replace the seal rings (5) to new ones.
• Apply transmission fluid to the seal rings and bearings.
• Take care not to damage the seal rings when installing the
support.
(1) External Snap Ring
(2) Feather Key
(3) 20T Gear Shaft
3-S28
TRANSMISSION
2
, 72 to 140 psi) is sent to
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(5) External Snap Ring
(6) Bearing
(7) 20T Gear Shaft
W1029698
(4) Bearing Support
(5) Seal Ring
W1030937
KiSC issued 06, 2007 A