Disassembling Pto Gear Case - Kubota M108S Workshop Manual

M108S, WSM

[7] DISASSEMBLING PTO GEAR CASE

Rear Cover Assembly
1. Remove the rear cover and PTO drive shaft as a unit.
(When reassembling)
Rear cover mounting
Tightening torque
screw
Disassembling Rear Cover
1. Remove the PTO case cover mounting screws and then remove
the PTO case cover (3).
2. Remove staking nut (4).
3. Remove the bearing (5) by using the bearing puller.
4. Tap out the PTO shaft (1) to the rear side.
5. Pull out the gear shaft (7) as a unit.
(When reassembling)
• Replace the PTO shaft staking nut (4) with new one, and stake it
firmly after tightening.
• Apply grease to the oil seal (8).
PTO shaft staking nut
Tightening torque
PTO case cover mounting
screw and reamer bolt
(1) PTO Shaft
(2) Rear Cover
(3) PTO Case Cover
(4) Staking Nut
3-S31
TRANSMISSION
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
W1033916
226 to 264 N·m
23 to 27 kgf·m
167 to 195 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(5) Bearing
(6) Gear
(7) Gear Shaft
(8) Oil Seal
W1034001
KiSC issued 06, 2007 A