Table of Contents
Advertisement
3.3 Buttons and Switches
3.3.1 Panel buttons
The ESC c 5 command enables the panel buttons. When disabled, none of the buttons will not
function.
1) Release button (RELEASE) (Non-locking push button)
Function: Release the paper.
2) Reverse button (REVERSE) (Non-locking push button)
Function: Feeds paper backward based on the line feed amount set by ESC 2 and ESC 3.
3) Forward button (FORWARD) (Non-locking push button)
Function: Feeds paper forward based on the line feed amount set by ESC 2 and ESC 3.
3.3.2 Power switch (located at the left side of the printer)
Function: Turns on or off the printer power. To start the self-test, hold down the release button and
press this switch.
Note:
This switch is located at the left side of the printer. When the printer is turned off using this
switch, the RAM is completely initialized.
3.3.3 DIP switches
1) For serial interface model
DIP Switch
1
1
2
3
4
5
6
7
8
9
10
EPSON
Table 3.3.1 DIP Switch 1
Function
Data receive error
Receive buffer capacity
Handshaking
Data word length
Parity check
Parity selection
Baud rate selection
Pin 6: Reset signal
Pin 25: Reset signal
TITLE
TM-U295/U295P
Specification
(STANDARD)
ON
Ignored
Data buffer 35 bytes
XON/XOFF
7 bits
Yes
Even
Transmission speed selection
Refer to Table 3.3.2.
Used
Used
SHEET
REVISION
F
OFF
Prints "?".
Data buffer 512 bytes
DTR/DSR
8 bits
No
Odd
Not used
Not used
NO.
NEXT
SHEET
22
21
Advertisement
Table of Contents
