When Left Unused/Transportation; When Left Unused - Epson SC-B7000 Series Service Manual

SC-F7000 Series/SC-B7000 Series

5.3 When left unused/transportation

5.3.1 When left unused

The following should be carried out if the printer is not used more than two weeks.
5.3.1.1 Preparation before leaving printer unused
REQUIRED TOOLS
Stubby screwdriver
Screwdriver
Cleaning cartridge (x4)
USB cable
Service program
Communication Driver
PROCEDURE
1. Turn on the printer.
2. Discard the waste ink.
3. Reset the counter for the waste ink bottle from the control panel.
Maintenance Waste Ink Counter
4. Start the service program and select
spec) from ADJUSTMENT (Sequence).
5. Select Auto CR unlock & move CR to full column
Press the [Run] button.
The CR lock is released and the CR Unit moves to the full side, then the printer
turns off automatically. (Page 56)
6. Clean where ink attaches to the parts such as around the print head, cap, wiper and
wiper rail.
7. Remove all the ink tanks and chip units and discard them.
8. Lower all the lock levers.
MAINTENANCE
[OK]
Procedure (Before no using printer over
side.
(Page 79)
When left unused/transportation
9. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
10. Select Ink eject.
Select All channels, and press the
11. Select Activation of Cleaning cartridge.
Select All channels, and press the
available. (Page 115)
12. Turn off the printer.
13. Install the cleaning cartridges. (Page 79)
14. Turn on the printer.
15. Discard the waste ink.
16. Reset the counter for the waste ink bottle from the control panel.
Maintenance Waste Ink Counter
17. Select Tube inner cleaning.
Select All channels and press the
18. Discard the waste ink.
19. Reset the counter for the waste ink bottle from the control panel.
Maintenance Waste Ink Counter
20. Select Switch between Ink cartridges and Ink
Select All channels and Ink Tank, and press the
tank available. (Page 114)
21. Turn off the printer.
22. Install the new ink tanks. (Page 79)
Revision A
[Run] button to run the ink eject. (Page 116)
[Run] button to make the cleaning cartridge
[OK]
[Run] button to charge the cleaning liquid.
[OK]
tanks.
[Run] button to make the ink
Confidential
126