Drum Cartridge Near End Of Life - Drum Life Near End - Fuji Xerox Phaser 5500 Service Manual

Low Toner Troubleshooting Procedure (Continued)
Step Actions and Questions
6
Check Toner Dispense Motor connections.
Are P/J216 and P/J420 connected?
7 Check continuity between the Toner
Dispense Motor and Engine Logic Board.
Is there continuity on each wire
between P/J216 <=> P/J420?
8 Check for +24 V to Toner Dispense Motor
Is there +24 V across P/J420-2 (+) <=>
ground?

Drum Cartridge Near End of Life - DRUM Life Near End

The Drum Cartridge is near its end of life count or the Drum Cartridge CRUM PWB
has failed to communicate with the Engine Logic Board.
Drum End of Life (Drum CRUM) Troubleshooting Reference
Applicable Parts
Drum Cartridge
Drum Cartridge
CRUM PWB
Engine Logic Board
Drum End of Life (Drum CRUM) Troubleshooting Procedure
Step Actions and Questions
1 Check the Drum Cartridge installation.
Was the Drum Cartridge replaced?
2 Check the Drum Cartridge CRUM PWB
installation.
Is the Drum Cartridge CRUM PWB
installed correctly?
3 Check the Drum Cartridge CRUM PWB
connection.
Are P126 and P/J419 connected?
Error Messages, Codes, and Procedures
References
Print Engine P/J Drum and Toner (page 10-6)
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Drive/CRUM Wiring (page 10-25)
PL5.1 Laser, CRU and Toner Dispense (page 9-32)
PL8.1 Print Engine Electrical (page 9-40)
Yes
Go to Step 7.
Go to Step 8.
Replace the Toner
Dispense Motor
(page 8-73).
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
No
Connect P/J216
and P/J420.
Repair the wiring.
Replace Engine
Logic Board
(page 8-89).
No
Replace the
Drum Cartridge. If
the error persists,
go to Step 2.
Correct the
installation.
Connect P126
and P/J419.
3-207