Siemens SINUMERIK 840DE sl Commissioning Manual page 1300

Animated elements
C.3 XML commands
Description
<ToolSpeedFactors
planeSpeedFactor="0.4"
rapidSpeedFactor="0.7"
reducedSpeedFactor="0.1" />
<!--Definition of an animation-->
<SceneKey name='BoringAnimation' masterRotationSpeed="-64.0"
maxRotAngle="45.0" begin-Time='0.110 endTime='0.118 view='camiso'
speedMaster='boringtool' Type="VIEW_3D_TURN_CYL">
Description
<SceneKey name='BoringAnimation'
masterRotationSpeed="-64.0"
maxRotAngle="45.0"
beginTime='0.110
endTime='0.118'
view='camiso'
speedMaster='boringtool'
type="VIEW_3D_TURN_CYL">
<!-- Elements -->
<Element name='1' time='0.110' feed='rapid' dwell='2'/>
<Element name='2' time='0.112' feed='rapid'/>
<Element name='3' time='0.114' feed='rapid'/>
<Element name='4' time='0.116' feed='plane'/>
<Element name='5' time='0.118' feed='plane'/>
Description
<Element name='1'
time='0.110'
314
This entry can be added if the tool speeds are
to be modified.
Factor for the feedrate ( 0.4 = 40% )
Factor for rapid traverse ( 0.7 = 70% )
Factor for a third speed ( 0.1 = 10% )
Name of the animation
Direction of rotation and rotation speed of the
tool.
The setting is optional.
To avoid aliasing effects (tool seems to be turn‐
ing in the wrong direction). The value is usually
a fourth of the symmetry of the tool.
The setting is optional.
Start time of the animation on the time sensor
End time of the animation on the time sensor
Camera to be used for the animation
Name of the tool for the animation
View type defines the view (see Section View
type (Page 316))
Specifies that it is the first element of the ani‐
mation.
Time of the first element on the time sensor
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1