Configuration Of The Network Adapter - Siemens SINUMERIK 840DE sl Commissioning Manual

Configuration of the system
4.16 Configuration of the Service Center
4.16.2

Configuration of the network adapter

You can make the network settings in the "Adapter Settings" tab and permanently save this
configuration, in contrast to the settings in the "Network Settings" dialog box of the Service
Center (Page 125).
Settings that you make in this dialog box are stored in the servicesystem.ini configuration
file.
Overview
You can make the following IP settings in the "Adapter Settings" dialog box:
Figure 4-3
Table 4-4 Settings in the "Adapter Settings" dialog box
Settings
Adapter
Use Windows Settings
Obtain an IP address automatically
(DHCP)
IP Address
Subnet Mask
64
Adapter settings - Ethernet 1 (company network)
Purpose
Select the Ethernet interface that you want to configure.
All settings in this dialog box refer to the selected Ethernet interface.
Select whether the values set in the Control Panel are to be used.
Select whether the addresses are to be fetched dynamically from the DHCP server.
If the checkbox is deactivated, you must make the settings manually.
Set the IP address of the NCU.
You can specify an IP address from the following range:
192.168.214.250 - 254
Specify a subnet mask, e.g. 255.255.255.0
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
PCU Base Software (IM10)