Siemens SINUMERIK 840DE sl Commissioning Manual page 1507

Backing up and restoring data
4.1 Overview
You can perform installation and commissioning work on the PCU in theService Center,
which is based on Microsoft Windows PE.
When the Desktop is active, configuration of the Service Center is possible via the
"ServiceCenter Backup-Restore" (Page 73) icon.
Most of the functions of the Service Center are available in the main menu (Page 88).
In particular, you can create or restore disk images in the Service Center. The following
options are available:
● Create a disk image of the SSD (Page 93)
● Restore a disk image of the SSD (Page 95)
● Create a disk image of a partition (Page 97)
● Restore a disk image of a partition (Page 99)
The Service Center uses the Symantec Ghost (Page 104) software, which you can also call
separately.
4.2 Starting the Service Center
To start the Service Center, proceed in one of the following ways:
● To call up the Service Center on the SSD while the PCU is starting, select the "Booting
● To call up the emergency boot system on a USB flash drive while the PCU is starting, set
● To switch to the Service Center while the Service Desktop (Windows 7) is active, click the
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
Service System" during startup in the Windows boot menu.
the service switch to E or press F12 during startup to show the boot selection.
"ServiceCenter Backup-Restore" icon on the Desktop and then click "Start
ServiceSystem".
4
87