Siemens SINUMERIK 840DE sl Commissioning Manual page 1272

Dialog selection
9.3 Dialog selection via NC
9.3 Dialog selection via NC
MMC command in HMI Operate
You can use MMC commands as described in the following:
1. Definition of MMC commands
The following combinations are available in the standard systemconfiguration.ini
file:
address:=MCYCLES --> command:=LM
address:=CYCLES --> command:=PICTURE_ON
This distinction is necessary, in order to make a differentiation between measuring cycles
and other cycles. This means that:
– LM is always applicable for measuring cycles, PICTURE_ON always for non-measuring
– It is not permissible that newly defined MMC commands are designated PICTURE_ON
2. "Run MyScreens" license
All of the dialogs opened by "Run MyScreen" – with the exception of the measuring cycles
– fall under the "Run MyScreens" license, and therefore without license, only a limited
number of dialogs can be used.
Example call with test.com (Run MyScreens):
g0 f50
MMC("CYCLES,PICTURE_ON,test.com,screen form1","A")
m0
MMC("CYCLES,PICTURE_OFF","N")
M30
286
cycles
and LM
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1