Siemens SINUMERIK 840DE sl Commissioning Manual page 1341

SNMPLocation
This string is used for the standard OID SNMPv2-MIB::sysLocation. It is possible to specify a
location here, which can be subsequently called with an SNMP client.
Value:
Default:
SNMPContact
This string is used for the standard OID SNMPv2-MIB::sysContact. It is possible to specify a
contact address here, which can be subsequently called with an SNMP client.
Value:
Default:
SNMPAutLocation
This string is used for the Siemens-specific OID
automationSystemIdent.automationLocationTag. It is possible to specify an additional location
here, which can be subsequently called with an SNMP client. This is similar to SNMPLocation
in terms of the MIB description, although it is intended for entries relating to automation.
Value:
Default:
SNMPFunction
This string is used for the Siemens-specific OID
automationSystemIdent.automationFunctionTag. It is possible to specify a function
designation here, which can be subsequently called with an SNMP client.
Value:
Default:
SNMPStation
This string is used for the SINUMERIK-specific OID
mcSinumerikMIB.mcSinumerikMiscStation. The value is the name of a station to which the
device belongs. Devices with the same station name are therefore identified as being
contiguous.
Value:
Default:
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Any character string
Empty
Any character string
Empty
Any character string
Empty
Any character string
Empty
Any character string
Empty
Configuring the system
2.3 Configuration file "basesys.ini"
23