Siemens SINUMERIK 840DE sl Commissioning Manual page 1118

Programming commands
6.2 Methods
6.2.9 OUTPUT
Description
The OUTPUT method is executed if the "GC" function is called. Variables and Help variables
are configured as an NC code in an OUTPUT method. The individual elements in a code line
are linked by means of blanks.
Note
The NC code can be generated in an extra file by means of file functions and transferred to
the NC.
Programming
Syntax:
Description:
Parameters:
Block numbers and skip identifiers
The OUTPUT method must not contain line numbers or skip identifiers if you wish to keep the
line numbers and skip identifiers directly set with active program support in the parts program
in case of recompilations.
Editor changes in the parts program produce the following response:
Condition
Number of blocks remains unchanged.
Number of blocks is reduced.
Number of blocks is increased.
Example
OUTPUT(CODE1)
"CYCLE82(" Var1.val "," Var2.val "," Var3.val ","Var4.val "," Var5.val ","
Var6.val ")"
END_OUTPUT
132
(Identifier)
OUTPUT
...
END_OUTPUT
Outputs variables in the NC program.
Identifier Name of OUTPUT method
Response
Block numbers are retained.
The highest block numbers are canceled.
New blocks are not numbered.
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Integrate Run MyScreens (BE2)