Siemens SINUMERIK 840DE sl Commissioning Manual page 1511

Overview
IP settings
You can make the following IP settings in the "Network Settings" dialog box:
Figure 4-2
Table 4- 2 IP settings in the "Network Settings" dialog box
Section Settings
Adapter configuration Adapter
DHCP Enabled
Address
Subnet
Default Gateway
Name Server
Host configuration Suffix Search List
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
Service Center - IP settings
Purpose
Select the Ethernet interface that you want to configure.
All settings in Section "Adapter configuration" refer to the selected Ethernet interface.
Select whether the addresses are to be fetched dynamically from the DHCP server.
If the checkbox is deactivated, you must make the settings manually.
Set the IP address of the NCU.
You can specify an IP address from the following range:
192.168.214.250 - 254
Specify a subnet mask, e.g. 255.255.255.0
Set the IP address of the standard gateway.
A standard gateway creates a standard route in the IP routing table for all destinations that
are not in the subnet.
Set the IP address of the name server.
A name server answers questions asked about a domain name zone using a DNS database.
Parameterize a search list for DNS suffix, e.g. "network.com".
The factory setting of the Ethernet interface "Local Area Connection" is ".local".
Backing up and restoring data
4.4 Network settings in the Service Center
91