Siemens SINUMERIK 840DE sl Commissioning Manual page 1694

Backing up and restoring data
6.8 Restore a disk image of a partition
3. Make the required settings here:
4. To start the restore process and entirely replace the existing data on the partition with the
disk image, confirm the settings with "Restore".
Result
The restore process is started.
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the restore process, the PC system will have no executable
system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in
again.
136
Section Settings
Base parame‐ Source file
ters
Destination par‐
tition
Base parame‐ Connect share
ters > Destina‐
tion partition
Select source
Purpose
Select the disk image from which the partition is to be restored.
You can use local disk images or disk images stored in the net‐
work.
Select the partition to be restored from the disk image.
Open the "Connect a Share" dialog box (Page 137).
You can manage a shared resource (e.g. a directory in the net‐
work), to use a disk image stored on the network to restore the
SSD.
Open the "Select source file" dialog box.
You can navigate through a local directory on the PC system
and select a disk image for restoration.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
PCU Base Software (IM10)