Siemens SINUMERIK 840DE sl Commissioning Manual page 1165

Icon
Desc_Text
Param_Text
Note
Notes on Icon, Desc_Text and Param_Text:
1. The user icon is always displayed in the G code editor. The G code icon is always displayed
in the ShopMill/ShopTurn editor. This helps to better distinguish between ShopMill/
ShopTurn steps and NON-ShopMill/ShopTurn steps.
2. The Run MyScreens step is dependent on the editor setting "Display cycles as machining
step". This applies to both the G code and the JobShop editor.
This means that when "Display cycles as machining step" = "YES", the "Desc_Text" of the
Run MyScreens configuration is taken; when "NO", the cycle is displayed.
3. Desc_Text and Param_Text
– can be specified according to language via the $xxxxx notation.
– The parameters of the cycle call generated can be accessed via %1, %2, etc. This
Example
//M(TestGC/"Code generation:")
DEF VAR1 = (R//1)
DEF VAR2 = (R//2)
DEF D_NAME
LOAD
VAR1 = 123
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1
involves the placeholder being replaced by the parameter that is specified after the '%'
in the parameter list generated.
(optional) icon for display in the machining step program, format
*.png
Screen size for corresponding resolution:
640 X 480 mm → 16 x 16 pixels
800 X 600 mm → 20 x 20 pixels
1024 X 768 mm → 26 x 26 pixels
1280 X 1024 mm → 26 x 26 pixels
1280 X 768 mm → 26 x 26 pixels
[system user directory] /ico/ico<resolution>
Archive:
Notes:
● For resolutions of 1280, the folder for 1024 x 768 mm is used
(only suitable for machining step programs).
● The screen size is not just dependent on the resolution, but also
on the font size set in the editor.
(optional) Explanation text for display in the machining step pro‐
gram, max. length of string is 17 characters (only suitable for ma‐
chining step programs).
(optional) Text for the parameter list
T=%1 D=%2
Programming commands
6.3 Functions
179