Siemens SINUMERIK 840DE sl Commissioning Manual page 995

Introduction
Overview
"Run MyScreens" can be used to create user interfaces that display functional expansions
designed by the machine manufacturer or user, or to implement your own layout.
Cycle calls can also be generated with user interfaces that you have created. Dialogs can be
created directly on the control system.
"Run MyScreens" is implemented with an Interpreter and configuration files that describe the
user interfaces.
"Run MyScreens" is configured using ASCII files: These configuration files contain the
description of the user interface. The syntax that must be applied in creating these files is
described in the following chapters.
Basic configuration
The "Run MyScreens" function enables machine manufacturers to configure their own dialogs.
Even with the basic configuration, it is possible to configure five dialogs in the operator menu
tree or for customer-specific cycle dialogs.
Supplementary conditions
The following conditions must be met:
● It is only possible to switch between dialogs within a single operating area.
● User variables may not have the same names as system or PLC variables (also see List
Manual System Variables /PGAsl/).
● The dialogs activated by the PLC form a separate operating area (similar to measuring
cycle screens).
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1
Software option
To expand the number of dialogs, you require one of the following software options:
● SINUMERIK 828D/840D sl, SINUMERIK Integrate Run MyScreens
(6FC5800-0AP64-0YB0)
● SINUMERIK 840D sl, SINUMERIK Integrate Run MyScreens + Run MyHMI
(6FC5800-0AP65-0YB0)
● SINUMERIK 840D sl, SINUMERIK Integrate Run MyHMI / 3GL
(6FC5800-0AP60-0YB0)
● SINUMERIK 840D sl, SINUMERIK Integrate Run MyHMI / WinCC
(6FC5800-0AP61-0YB0)
1
9